2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article1999 Ford F-Super Duty 250-550 Automatic Transaxle/ Transmission Cable and...
download 1. NOTE: To prevent cable damage, do not apply force to the transmission shift cable assembly between the steering column shift tube bracket and the steering column bracket. Disconnect the...
View ArticleChevrolet LCT1000 LCT2500 Transmission removal, Installation And testing
download Removal NOTE; NOTE: NOTE: Check and record all codes and actions of your transmission before transmission is removed. This will help if you still have problems after installation. Damage to...
View Article2006 Ford Freestyle Transmission Fluid Drain and Refill GENERAL PROCEDURES
download NOTICE: The use of any fluid other than what is recommended for this transmission will cause transmission damage. Draining 1. With the vehicle in NEUTRAL, position it on a hoist. For...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article2006 Ford Crown Victoria Automatic Transaxle/ Transmission REMOVAL
download NOTICE: Whenever a transmission has been disassembled to install new parts, the transmission fluid cooler tubes must be cleaned and backflushed using a suitable torque converter/fluid cooler...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article2006 Ford Explorer Transmission Fluid Refill procedure
download Transmission Fluid Refill NOTICE: This procedure contains the air purge steps required to purge air from the cooling system. This procedure is NOT intended for use with the Transmission Fluid...
View Article2003-2005 Chevrolet TrailBlazer Automatic Transmission/Torque Converter...
download Automatic Transmission/Torque Converter Clutch (TCC) Shudder, Water in Transmission (Repair Transmission and Replace Transmission Filler Tube, Level Indicator and Seal) Condition Some...
View Article
